Logo

PIKO solar reflective cassette roller blind

https://toma24.com/productcart/piko-solar-reflective-cassette-roller-blind
Gross: 16.99 GBP
Net: 13.81 GBP
Producent: toma
Technical data:
Blind length - range
30-110 cm
Blind width - range
20-140 cm
Cassette/Masking plate
Yes
Colour of fixings
White
Fabric type
Solar reflective fabrics
Manufacturer
toma
Material of fixings
Aluminium, PVC
Measure unit
Pcs.
Type of blind
PIKO cassette roller blind with guide rails
Type of mounting
Window sash
Warranty:
Warranty time
24 months
Description:

Cassette roller blind PIKO is a system designed for small windows. PIKO blind has an outstanding flat  cassette and thin flat side PVC rails in a white colour. Due to flat guide rails and gentle shape of a cassette the entire blind is an integral part of a window. PIKO roller blind is a non-invasive system fixed to a window sash. Solar reflective fabrics ideally protects from overheating of the interior.

FEATURES

ADVANTAGES

ADDITIONAL INFORMATION

Measurement:

Measurement of a cassette roller blind PIKO is very easy. Following the manual enables proper measuring and eventual mounting of the blinds.

Making measurements provide only width and height of the glass with the glazing beads according to the instructional picture below.

In case of round glazing beads 2 cm extra are added to the provided width of the roller blind to fit the guide rails. To mount the guide rails properly at least 1 cm of flat surface is needed on each side of the window frame.

The entire width of the blind is approx. 3 cm larger than the width of the fabric (glass+glazing beads).

Please, provide glazing width in remarks to your order.

Mounting:

Mount of a cassette roller blind PIKO is very easy. The blind is mounted to a window sash with special tapes.

MANUAL HOW TO MOUNT A CASSETTE ROLLER BLIND WITH GUIDE RAILS

a. cassette

b. guide rail

c. end cap

d. pulley set

e. glazing bead

f.  window sash

step one - surface preparation

Window frame needs to be cleaned in places where a cassette and rails will be fixed

step two - guide rails mount

Remove a protection of an adhesive tape and glue two guide rails on both sides of  a window sash 1 centimetre from a glazing bead. Fixing rails should start from a handle side.

In case when  the distance from a handle to a glazing bead is shorter than 1 centimetre the guide rail should be fixed maximally close to the handle. Glue another rail proportionally far from a glazing bead as to place the roller blind in the central part of the window

step three - cassette mount

After having fixed guide rails remove protection of a cassette tape and glue it on the upper part of a window sash in such a way to put its edge in the same place as the rail’s edge. There should be a right angle between the rails and the cassette.

step four - setting the chain blockade

Next step is setting the brake in a roller blind. The fabric needs to be unrolled as to place the bottom bar evenly to rails edges. Additional blocker should be fixed near a cassette.

In the instructional video the guide rails are mounted on the glazing beads.

Such a solution is possible only with the flat glazing beads.

In case when the glazing beads are round the guide rails should be mounted next to them what, in effect, increases the entire width of the blind by at least 2 cm.

NOTE: Please measure according to the instructions in the "Measure" tab and not the following film. The film was included as an assembly instruction for blinds and not a measurement.

DISMOUNTING MANUAL

In order to dismount a cassette roller blind it is necessary to cut a tape along the cassette with a wallpaper knife until it is entirely cut off. Clean a blind and a window from tape wastes. A new tape needs to be used in case of another mounting.